Using the Loop Turner Tool to Load Drawstring in a Cord Stop

Sometimes it can be tricky to figure out how to do something that seems like it should be super easy. One example of this (for me) was loading a drawstring through a cord stop, as is required in my Got Sudz soap bag pattern.

There are lots of different ways of doing it, but the fastest way I’ve found is to use my Loop Turner Tool by ToolTron to pull the drawstring through. If you don’t have the Loop Turner Tool by ToolTron but you do have a tiny crochet hook, that will work as well!

To do this using the Loop Turner Tool, first, hold the cord stop in your hand and squeeze down the top push tab several times to warm up the spring.

Next, hold the tab down while you insert the latch hook end of the Loop turner through one of the cord stop holes. Release tab gently and load drawstring onto latch hook as shown:

After you’ve done the above, press the cord stop spring tab down again then pull the loop turner latch hook back through the hole of the cord stop, like so:

Now, repeat this with the other hole of the cord stop using the other drawstring end. Once both ends are loaded, press the spring tab and slide the cord stop up and down a few times while you even the length of the drawstrings and position the cord stop where you want it.

Trim drawstring to the length you desire then finish by tying the drawstring ends together in a knot and trim ends again, fairly close (about 1/2 inch or closer) to knot.

And that’s all there is to it! Have you used this method with either the Loop Turner or a tiny crochet hook? Let me know in the comments below!

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.